07-09 Tundra Replacement Cam - For Overhead Display!

In Stock
07-09 Tundra Replacement Cam - For Overhead Display! is available to buy in increments of 1

THIS PRODUCT IS SPECIFICALLY FOR TRUCKS WITH THE OVERHEAD 3.5" DISPLAY IN THE SUNGLASS HOLDER AREA.  Finally an affordable solution for trucks with the factory overhead 3.5" screen to replacing your burned out factory Tundra camera!  SEE COMPATIBILITY BEFORE ORDERING!

This kit utilizes our ultra clear super CMOS camera and is available in the following handle configurations:
  • Camera module only - does not come with a handle, allows you to get your own handle but you must get one with rear camera opening
  • Camera module premounted in OEM Toyota handle.  This option uses a factory Toyota handle and is completely assembled and ready to install
  • Camera module premounted in aftermarket handle.  This option is the same as above but in an aftermarket Tundra handle with camera opening


This is a plug and play replacement module for your factory camera on 2007-2009 Toyota Tundra series pickup trucks WITH THE SMALL MONITOR IN THE SUNGLASSES AREA (commonly called flip down monitor). Simply remove your old camera module from the bezel and replace with this new module! Installation time is less than 15 minutes and save $$HUNDREDS$$ over a factory replacement module that is priced at over $800!


NOTE: This is a 6 volt camera and is designed to replace an existing Tundra camera.  Toyota overhead monitors produce 6 volts to the camera output and require this camera as it is a compatible CMOS that runs on 6 volts.   This kit will also work if you are purchasing a factory Toyota flip down monitor part number PT923-00081-11 or similar.


Camera specifications:

  • Super CMOS 6v sensor - ultra clear picture and color contrast
  • <.2 LUX night vision
  • 600 TVL of resolution
  • Factory parking guidelines - optional turn on and off at the harness
  • Requires 6 volt input
  • 2007-2009 plug and play OEM Toyota harness included - specify year at time of order (2010 pictured)
  • 3 year warranty!


More Information
Video System NTSC
Waterproof/Dustproof Level IP 67
Night Vision < .2 Lux
Power Supply 6 Volts
Wiring Type Factory Plug&Play
System Manufacturer EVI Systems
Camera Resolution 600 TVL
Parking Guidelines Selectable on/off
Camera Orientation Rear Facing
Fit Type Factory OE Fit Replacement
Connection Factory Connector
Sensor Type Super CMOS
Viewing Angle 170 Degrees
Warranty 3 Year
I'm Looking For: Rear Camera
Reason for Shopping Factory camera failed/need replacement
For a monitor it uses: Your factory display

2007, 2008, 2009 Toyota Tundra with existing backup camera and flip down overhead monitor.  NOT COMPATIBLE WITH TRUCKS THAT HAVE THE DISPLAY IN THE MIRROR OR NAVIGATION UNIT.  PLEASE SEE PART NUMBER CS-7TUNOEM-M.


This kit will also work when combined with Toyota part number PT923-00081-11 or other color variants of this part number.  

If you purchase just the camera module you will install our camera module into your camera-ready handle using the included bolts, route the harness through the bottom of tailgate and plug in on the frame rail.  This will only bolt into a factory or aftermarket handle with the OEM camera opening.  You can not drill a hole and make this system work.
If you purchase in a handle simply replace your existing tailgate handle with this handle containing the integrated backup camera. Two 10mm bolts hold your handle in place, swap the lock, fish the camera wire through the tailgate, plug in to your chassis, and reassemble. The entire camera installation process can take less than 20 minutes. Monitor installation time may take additional time if applicable.
Create a review here

  • Write Your Own Question