07-13 Tundra Full Harness Camera Kit-DEMO

Comes with complete RCA harness

SKU: CS-TUNHU-FH

Regular Price: $199.00

Special Price $69.00

Regular Price: $199.00

Special Price $69.00

OR

Email to a Friend

Description

Details

**DEMO** Used for testing.  Like new condition!

This is aTundra backup camera kit with full length RCA 12v harness- it connects to any monitor with RCA input.  NOTE: if you are prewired use our OEM plug and play system to save time!  This kit utilizes our ultra clear super CMOS camera and is available in the following handle configurations:

  1. Camera module premounted in aftermarket handle.  This option is the same as above but in an aftermarket Tundra handle with camera opening

 

Base kit includes:

  • Aftermarket Toyota tailgate camera handle with Camera Source 12 volt Super CMOS night vision camera OE fit camera premounted.
  • 25' pre-loomed rear harness - RCA connector for seamless integration into any aftermarket monitor with RCA input 
  • Zip ties
  • Detailed installation instructions

Camera Specifications:

  • Super CMOS chip - outstanding color, contrast, and clarity!
  • 170 degree view
  • 600 TV lines of resolution
  • NO parking guidelines
  • 12 volt rating, (**see 6v note below)
  • <.2 lux minimum illumination - Outstanding night vision!

This kit allows you to see what is directly behind the truck - it will even see the rear bumper and hitch! Save $$$hundreds$$$ over a factory kit!

 

No monitor or mirror is included in this kit.

 

Additional Information

Additional Information

SKU CS-TUNHU-FH
Video System NTSC
Vehicle Interface Not Included
Waterproof/Dustproof Level IP 67
Night Vision < .2 Lux
Power Supply 12 Volts
Wiring Type Hard Wired Full Harness
System Manufacturer EVI Systems
Camera Resolution 600 TVL
Parking Guidelines Not Available
Camera Orientation Rear Facing
Fit Type Factory OE Fit Replacement
Connection Aftermarket Display (RCA)
Sensor Type Super CMOS
Viewing Angle 170 Degrees
Warranty 1 Year Limited
Compatibility

2007-2013 Tundra 

 

 

Installation Information

Replace your existing tailgate handle with this handle containing the integrated backup camera. Two 10mm bolts hold your handle in place, swap the lock, route the wiring, and reassemble.

The chassis harness has a quick disconnect that will allow you to easily remove the tailgate if desired.