2007 - 2012 GM Truck Backup Camera VSS1 Adapter

In Stock
2007 - 2012 GM Truck Backup Camera VSS1 Adapter is available to buy in increments of 1

RCA VSS harness adapter for NBS GM vehicles with navigation. Allows for a video input connection to the factory nav unit.


Use this adapter to connect your backup camera to the factory navigation in your 2007-2012 (non hard drive radio) GM truck or SUV. If you did not have navigation from the factory you will need the VSS full connector harness part # CS-GMVSS2.


Not required for aftermarket navigation units.

More Information
Wiring Type Factory Plug&Play
System Manufacturer EVI Systems
Connection Plug and Play to Factory Dash Display

2007-2012 (non hard drive radios) with navigation from the factory. If you are adding navigation to your truck you will need part # CS-GMVSS2.


NOTE: if you have a 2012 or newer factory hard drive radio please contact us for an interface.

Disconnect the brown connector from your VSS plug on the back of the radio, pull out the red connector lock pin from the brown connector, push the two wires into the appropriate pin location as labeled on the adaptor. This will provide a female RCA connection so you can add a backup camera to your factory navigation.


NOTE: you will still need to have your navigation flashed for a backup camera by your local GM dealer. The flashing process is what changes your navigation into camera mode when in reverse.  Watch the video below to learn how to flash your GM radio for rear camera.


Watch the following video to see how to install the VSS1 connector as part of our GM truck camera installation video below:



Create a review here

  • Write Your Own Question