10-17 Tacoma Flush Mount Camera Kit - Plug and Play

Uses your factory camera connector!

SKU: CS-TAC-FM

$199.00
$199.00
OR

Email to a Friend

Description

Details

Camera is FMVSS 111 compliant!  New Product in stock and ready to ship!  This is a plug and play camera kit that will allow you to replace your factory tailgate camera with this rear facing flush mount camera!

 

This universal camera mounts flush with a flat surface.  Drill a 22.5mm hole(hole saw included) and run the cable through to your factory backup camera connection.

 

Use this camera for bed campers, utility beds or any other application where you are required to remove your factory tailgate. Simply mount the camera in any flat surface and run the included 6' cable to your factory backup camera connection behind the rear bumper for a simple and seamless installation. 

 

Kit includes the following:

  • Black rear facing flush mount camera with our latest super CMOS camera - the latest camera technology!
  • Mounting hardware
  • OEM conversion harness-approx 6 feet of wiring total  
  • 22.5 mm hole saw
  • Zip ties
  • Installation instructions
  • 3 year limited camera warranty

Camera Specifications:

  • Super CMOS chip - outstanding color, contrast, and clarity!
  • Removable parking guidelines
  • 170 degree view
  • 600 TV lines of resolution
  • .1 lux minimum illumination - Outstanding night vision!
Additional Information

Additional Information

SKU CS-TAC-FM
Video System NTSC
Waterproof/Dustproof Level IP 67
Night Vision < .2 Lux
Power Supply 6 Volts
Wiring Type Factory Plug&Play
System Manufacturer EVI Systems
Camera Resolution 600 TVL
Parking Guidelines Selectable on/off
Camera Orientation Rear Facing
Fit Type Universal fit
Connection Factory Connector
Sensor Type Super CMOS
Sensor Brand EVI Systems
Viewing Angle 170 Degrees
Warranty 3 Year Limited
Compatibility

2010-2017 Tacoma with factory installed backup camera.

 

NOTE: vehicle must have come from the factory with a rear camera in order for this kit to function. Exception is some 2014+ vehicles are prewired directly to the radio so this kit will plug right in and function even if your truck didn't come with a camera.

Installation Information
Camera requires a 22.5 mm hole on a flat surface for flush mounting.  It will require a flat section approximately 1" x 1" for mounting.  Drill the hole and connect the camera harness to the OEM conversion harness.  Run the cable to your factory backup camera connection under the truck and plug it in.
There is approximately 6' of wire between the camera and the factory connector.