2017+ Super Duty w/ 360 view-Relocation kit with camera included

Camera included!



Email to a Friend



The innovative 360-degree camera system found on 2017+ Ford Superduty trucks gives drivers an unparalleled view of their surroundings while maneuvering in close-quarters situations where safety is paramount. Aftermarket truck equipment manufacturers and upfitters often lose this around-view capability altogether when removing a Superduty Truck’s tailgate with built-in camera.
This is a universal mounting bracket with a premounted OEM camera and 14 foot extension harness that will allow you to relocate your factory installed tailgate camera on your 2017+ Ford Super Duty truck that has the 360 degree view system!  Use this for any application where you are required to remove your factory tailgate.
Simply unplug your factory camera behind the rear bumper and remove your tailgate.  Install the relocation housing with pre-mounted OEM camera and mount on any flat surface.  Run the camera coaxial harness to the factory camera plug and reconnect.
The camera will function the same as before, just in a different location. 
This kit is only compatible with Super Duty trucks that came from the factory with a tailgate camera and the 360 degree camera system.  Display not included.  
Kit includes the following:
  • Universal mounting bracket with pre-mounted OEM camera
  • 14 foot extension harness
  • Hardware
  • One year warranty!
Additional Information

Additional Information

Bracket Type Universal Surface mount
Number of Cameras 1
Wiring Type Factory Plug&Play
System Manufacturer Rostra
Camera Resolution 480 TVL
Camera Orientation Rear Facing
Connection Factory Connector
Warranty 1 Year Limited

2017+ Ford Super Duty trucks- F250, F350, F450, F550 that came from the factory with the 360 degree view system.

This kit provides a way of maintaining Ford’s 360-degree camera system after the vehicle’s tailgate has been removed.
Installation Information
Unplug your existing factory tailgate camera under the truck. 
Mount the universal surface mount housing with camera assembly to any flat surface. 
Run the camera extension harness to the factory plug under the truck and connect.  
Q & A

Q: Can I get just the bracket and extension harness without the camera? 

A: Yes!  See SKU: CS-FTRSK-17SDR.  This is for the relocation bracket and 14 foot extension harness only.  You will need to remove your factory camera from the tailgate handle and install it into the relocation bracket.  Then plug the extension harness into the factory connector.

Q:  What are the dimensions of the bracket?

A:  4 3/8"L x 1 1/2" W x 1 1/3" H