RAM Flush Mount Cam Kit-Manual Splice

Manual splice flush mount camera kit

SKU: CS-DTRSK-FMMS

$199.00
$199.00
OR

Email to a Friend

Description

Details

FMVSS 111 compliant!  Rear facing flush mount camera!  Kit is not plug and play and requires manual splicing into the factory camera harness.

 

This universal camera mounts flush with a flat surface.  Drill a 22.5mm hole(hole saw included) and run the cable through to your factory backup camera connection. 

Kit includes the following:

  • Black rear facing surface mount camera with our latest super CMOS camera - the latest camera technology!
  • Mounting hardware
  • Open ended harness for splicing into factory harness
  • 22.5 mm hole saw
  • Zip ties
  • Installation instructions
  • 3 year limited camera warranty

Camera Specifications:

    • Super CMOS chip - outstanding color, contrast, and clarity!
    • Removable parking guidelines
    • 170 degree view
    • 600 TV lines of resolution
    • .1 lux minimum illumination - Outstanding night vision!

Additional Information

Additional Information

SKU CS-DTRSK-FMMS
Video System NTSC
Waterproof/Dustproof Level IP 67
Night Vision .1 Lux
Power Supply 12 Volts
System Manufacturer EVI Systems
Camera Resolution 600 TVL
Parking Guidelines Selectable on/off
Camera Orientation Rear Facing
Fit Type Universal fit
Connection Factory Connector
Sensor Type Super CMOS
Sensor Brand EVI Systems
Viewing Angle 170 Degrees
Warranty 3 Year Limited
Compatibility

Any Ram truck with a factory installed backup camera.

**EVI Systems has certified this camera system to comply with FMVSS 111 regulations as set forth by the National Highway Traffic Safety Administration (NHTSA).  Testing has been performed jointly in-house and by a certified laboratory to meet or exceed the minimum requirements set forth by TP-111-V-01.  FMVSS 111 field of view requirements and any other vehicle related certification is ultimately the responsibility of the vehicle up-fitter to ensure compliance. 

 

 

 

 

 

 

Installation Information
Camera requires a 22.5 mm hole on a flat surface for flush mounting.  It will require a flat section approximately 1" x 1" for mounting.  Drill the hole and connect the camera harness to the manual splice harness.  Run the cable to your factory backup camera connection under the truck and manually splice. Pinout details included in the install instructions.
There is approximately a total of 6' of wire between the camera and the factory connector.