Super Duty 3rd Brake Light Cam for Trucks w/ factory camera & 4.2 Display

Plug & Play with your factory 4.2" display!



Email to a Friend



This kit includes a plug and play harness that will allow you to use your 4.2" factory radio display and toggle between your factory installed tailgate camera and this third brake light camera when in reverse.  This is a trim bezel with premounted camera that fits behind your factory 3rd brake light and the camera connects to the same connector that your factory rear camera uses.  Adds the rear camera convenience to the top of your cab!  Now you can see your fifth wheel or anything else that is inside your bed without having to have a spotter guiding you for trailer connections etc.

The included harness allows you to choose which camera you want to display when in reverse. A switch determines which camera will be displayed when in reverse.

Notes about the included integration cable:

  • Truck must have a rear view camera that was installed at the factory and is displayed on your 4.2" factory radio screen
  • Kit includes a harness that allows you to connect both your factory tailgate camera and this 3rd light camera to your factory radio.  The switch allows you to choose which one is displayed in reverse.  

Camera Specifications:

  • 3rd brake light trim bezel with premounted camera
  • HD CMOS, high resolution color and night vision
  • Adjustable view, swivel head allows you to aim the camera where needed
  • 500 TV Lines of resolution
  • 150 degree view
  • <.2 LUX night vision
  • 3 Year warranty



Additional Information

Additional Information

Vehicle Interface Not Included
Waterproof/Dustproof Level IP67
Night Vision < .2 Lux
Power Supply 12 Volts
Wiring Type Hard Wired Full Harness
System Manufacturer EVI Systems
Camera Resolution 500 TVL
Camera Orientation Rear Facing
Fit Type Factory OE Fit Replacement
Connection RCA with opt. Factory Interface
Sensor Type CMOS
Sensor Brand EVI Systems
Viewing Angle 150 Degrees
Warranty 3 Year Limited

2013-2016 Ford Super Duty trucks with a factory tailgate camera and 4.2" factory display.  

Installation Information

Remove your factory 3rd brake light and install the trim bezel from this kit, then reinstall your factory light.  Remove the radio to gain access to the camera connector, install new plug and play harness,  route camera harness to the T-harness and make connections.  Power connections for camera must also be made inside the cab.  

Make installation even easier with an add on 12 Volt power source to eliminate the need to locate a power source on the vehicle and avoid cutting or splicing into factory wiring!  See related item SKU: CS-RPW-P

Q & A

Q: Does this include a complete new factory 3rd brake light?

A: No, this is a trim bezel with a premounted camera that fits behind your existing factory 3rd brake light.

Q: Do I have to splice into any of the factory wiring?

A: No, This kit is plug and play.