2017+ Super Duty Backup Camera for 4.2" MyFord Display

Factory OEM handle with Cam!

SKU: CS-17FTRHD-42

$449.00

* Required Fields

$449.00

Email to a Friend

Description

Details

This is a OEM backup camera solution for your Ford Super Duty truck ! This will fit the new generation 2017+ Super Duty pickup trucks as a direct factory replacement handle with pre-mounted CMOS camera.  This kit will look like it was installed at the factory, but cost you a fraction of the price! 

Kit includes:

  • CMOS III camera mounted in an OEM Ford rear handle system. Handle available in Black or Chrome.
  • 25' wiring harness 
  • Integration module for your factory 4.2" display (display not included)
  • Wire connectors
  • Zip ties
  • Detailed installation instructions

Camera Specifications:

  • CMOS III 
  • 150 degree view
  • 500 TV lines of resolution
  • .2 lux minimum illumination 

 This kit allows you to see what is directly behind the truck and will look like it came from the factory! Note: In order to see the trailer hitch the camera view also shows a small portion of the edges of the handle.  See product images for a picture of the actual view. 

Display is not included as this kit connects to your existing factory display. 

 

 

 

 

Additional Information

Additional Information

SKU CS-17FTRHD-42
Video System NTSC
Vehicle Interface Includes Factory Integration Module
Waterproof/Dustproof Level IP 67
Night Vision .2 Lux
Power Supply 12 Volts
Number of Cameras 1
Wiring Type Hard Wired Full Harness
System Manufacturer EVI Systems
Camera Resolution 500 TVL
Parking Guidelines Selectable on/off
Camera Orientation Rear Facing
Fit Type Factory OE Fit Replacement
Connection RCA with opt. Factory Interface
Sensor Type CMOS III
Viewing Angle 150 Degrees
Warranty 3 Year Limited
Compatibility
Compatible with 2017+ F250, F350, F450, and F550 with a 4.2" MyFord factory display.
 
 
Installation Information
The rear camera kit will replace your factory rear tailgate handle.  Route the power/video RCA into the cab and connect to the integration module. 
 
The Multi-cam integration module is plug and play with your factory MyFord 4.2" screen.  You will need to remove your factory 4.2" screen to gain access to the back of the connections. The module will be plug and play and stubs out to a RCA for the camera to connect directly to the screen.  No cutting or splicing of factory wires and the interface module supplies the power.