2017+ Super Duty Backup Camera for 8" SYNC 3 Display

Factory OEM handle with Cam!

SKU: CS-17FTRHD-OBDS3

$378.00

* Required Fields

$378.00

Email to a Friend

Description

Details

This is a OEM backup camera solution for your Ford Super Duty truck ! This will fit the new generation 2017+ Super Duty pickup trucks as a direct factory replacement handle with pre-mounted CMOS camera.  This kit will look like it was installed at the factory, but cost you a fraction of the price! 

Kit includes:

  • CMOS III camera mounted in an OEM Ford rear handle system. Handle available in Black or Chrome.
  • 25' wiring harness 
  • OBD Genie programmer for radio
  • T-harness to create the camera connection to your factory radio
  • Wire connectors
  • Zip ties
  • Detailed installation instructions

Camera Specifications:

  • CMOS III 
  • 150 degree view
  • 500 TV lines of resolution
  • .2 lux minimum illumination 

 This kit allows you to see what is directly behind the truck and will look like it came from the factory!  Note: In order to see the trailer hitch the camera view also shows a small portion of the edges of the handle.  See product images for a picture of the actual view.  This camera comes with a 3 year warranty and is guaranteed to fit or your money back. Professional installation is recommended. 

 

 

 

 

Additional Information

Additional Information

SKU CS-17FTRHD-OBDS3
Video System NTSC
Waterproof/Dustproof Level IP 67
Night Vision .2 Lux
Power Supply 12 Volts
Number of Cameras 1
Wiring Type Hard Wired Full Harness
System Manufacturer EVI Systems
Camera Resolution 500 TVL
Parking Guidelines Selectable on/off
Camera Orientation Rear Facing
Fit Type Factory OE Fit Replacement
Connection RCA with opt. Factory Interface
Sensor Type CMOS III
Viewing Angle 150 Degrees
Warranty 3 Year Limited
Compatibility
Compatible with 2017+ F250, F350, F450, and F550 with an 8" SYNC 3 display.
 
 

 

 

 

 

Installation Information
The rear camera kit will replace your factory rear tailgate handle.  Route the power/video RCA into the cab.  Open the dash to access the back of your factory SYNC 3 display and connect the included T- harness to the display.  Connect camera power wire to a 12v reverse power source. Connect black ground wire to a suitable ground on the frame.  
Make installation even easier with an add on 12 Volt power source to eliminate the need to locate a power source on the vehicle and avoid cutting or splicing into factory wiring!  See related item SKU: CS-RPW-P
 
Plug the OBD Genie into your truck's OBD port under the steering column to program the radio.  Takes less than a minute to program!