This kit includes a plug and play harness that will allow you to use your 8" factory radio display and toggle between your factory installed tailgate camera and this third brake light camera when in reverse. This is a trim bezel with premounted camera that fits behind your factory 3rd brake light and adds the rear camera convenience to the top of your cab! Now you can see your fifth wheel or anything else that is inside your bed without having to have a spotter guiding you for trailer connections etc. Adds a trim bezel with premounted camera to your factory third light assembly and the camera connects to the same connector that your factory rear camera uses. The included plug and play harness allows you to choose which camera you want to display when in reverse. A switch determines which camera will be displayed when in reverse.
Notes about the included integration cable:
- Truck must have a rear view camera that was installed at the factory and is displayed on your 8" factory radio screen (2013-2016 models only)
- Kit includes a plug and play harness that allows you to connect both your factory tailgate camera and this 3rd light camera to your factory radio. The switch allows you to choose which one is displayed in reverse.
- 3rd brake light trim bezel with premounted camera
- HD CMOS, high resolution color and night vision
- Adjustable view, swivel head allows you to aim the camera where needed
- 500 TV Lines of resolution
- 150 degree view
- <.2 LUX night vision
- 3 Year warranty
- Additional Information
SKU CS-FTR3LSD-FI Vehicle Interface Not Included Waterproof/Dustproof Level IP67 Night Vision < .2 Lux Power Supply 12 Volts Wiring Type Hard Wired Full Harness System Manufacturer EVI Systems Camera Resolution 500 TVL Camera Orientation Rear Facing Fit Type Factory OE Fit Replacement Connection RCA with opt. Factory Interface Sensor Type CMOS Sensor Brand EVI Systems Viewing Angle 150 Degrees Warranty 3 Year Limited
2013-2016 Ford Super Duty trucks with 8" factory display and factory tailgate camera.
- Installation Information
Remove your factory 3rd brake light and install the trim bezel from this kit, then reinstall your factory light. Remove the radio to gain access to the camera connector, install new plug and play harness, route camera harness to the T-harness and make connections. Power connections for camera must also be made inside the cab.
Optional 12 Volt power source available to eliminate the hassle of locating a power source on the vehicle and avoid cutting or splicing into factory wiring! See related items SKU: CS-RPW and CS-RPW-P
- Q & A
Q: Does this include a complete new factory 3rd brake light?
A: No, this is a trim bezel with a premounted camera that fits behind your existing factory 3rd brake light.
Q: Do I have to splice into any of the factory wiring?
A: No, This kit is plug and play.