Camera Source is not currently experiencing any shipping delays due to COVID-19.

Flush Mount Camera with RCA Harness

Mount on any flat surface!



Email to a Friend



Camera is FMVSS 111 compliant!  Adding a backup camera to ANY car or truck could never be simpler!
This CMOS flush mount backup camera kit will allow you to integrate rear view safety to any vehicle with a flat surface! The 25' long harness terminates with a RCA connection so you can integrate into any monitor with an RCA video input. The camera has parking guideline options, meaning that the guidelines can be turned off. This camera can also be used as a front camera by simply switching it to a forward looking image on the harness during the installation!

Camera Specifications:

  • Flush Mount Super CMOS chip - outstanding color, contrast, and clarity!
  • Removable parking guidelines
  • Image: Mirror/Non mirror switchable
  • 170 degree view
  • 600 TV lines of resolution
  • .1 lux minimum illumination - Outstanding night vision!
  • 3 year limited warranty!



Additional Information

Additional Information

Night Vision < .2 Lux
Power Supply 12 Volts
Number of Cameras 1
Wiring Type Hard Wired Full Harness
System Manufacturer EVI Systems
Camera Resolution 600 TVL
Parking Guidelines Selectable on/off
Camera Orientation Front or Rear Facing
Fit Type Universal fit
Connection Aftermarket Display (RCA)
Sensor Brand EVI Systems
Viewing Angle 170 Degrees
Warranty 3 Year Limited
Will work with any 12v system.
Installation Information
Camera requires a 22.5 mm hole on a flat surface for flush mounting.(Hole saw included)  It will require a flat section approximately 1" x 1" for mounting.  Install the camera and run the harness to the front of the vehicle.  Find a 12V reverse or accessory power source for the camera.
Make installation even easier with an add on 12 Volt power source to eliminate the need to locate a power source on the vehicle and avoid cutting or splicing into factory wiring!  See related item SKU: CS-RPW-P

Q & A
Q:  What size hole do I need to drill to mount the camera?
A:  A 22.5 mm hole drill bit is included in the kit.