Replacement Camera for 08-09 Tundra - Plug & Play

Replaces burned out Tundra camera!

SKU: CS-7TUNOEM-M

$219.00
$219.00
OR

Email to a Friend

Description

Details

Finally an affordable solution to replacing your burned out factory Tundra camera!

 

This is a plug and play replacement module for your factory camera on 2008-2009 Toyota Tundra series pickup trucks (not for flip-down monitors.  If you have an overhead flip down display you need the part number that ends with -FDM). Simply remove your old camera module from the bezel and replace with this new module! Installation time is less than 15 minutes and save $$HUNDREDS$$ over a factory replacement module that is priced at over $800!

 

NOTE: This is a 6 volt camera and is designed to replace an existing Tundra camera. Toyota navigation units and mirrors produce 6 volts to the camera output and require this camera as it is a compatible CMOS that runs on 6 volts. If your Tundra didn't come with a camera and are looking to add one see our complete lineup of 12 volt Tundra camera kits!

 

Camera specifications:

  • Super CMOS 6v sensor - ultra clear picture and color contrast
  • <.2 LUX night vision
  • 600 TVL of resolution
  • Factory parking guidelines - optional turn on and off at the harness
  • Requires 6 volt input
  • 2007-2009 plug and play OEM Toyota harness included
  • 3 year warranty!

NOTE: Not suitable for Toyota flip down monitors.  IF you have a flip down monitor order part number CS-7TUN-FDM.

Additional Information

Additional Information

SKU CS-7TUNOEM-M
Video System NTSC
Waterproof/Dustproof Level IP 67
Night Vision < .2 Lux
Power Supply 6 Volts
Wiring Type Factory Plug&Play
System Manufacturer EVI Systems
Camera Resolution 600 TVL
Parking Guidelines Selectable on/off
Camera Orientation Rear Facing
Fit Type Factory OE Fit Replacement
Connection Factory Connector
Sensor Type Super CMOS
Viewing Angle 170 Degrees
Warranty 3 Year Limited
Compatibility

2008, 2009 Toyota Tundra with existing backup camera. Not compatible with Toyota flip down monitors or trucks that did not ship from the factory with a camera.  If you are looking to add a camera to your Tundra please check out our other items.

Installation Information

Remove the torx screws on the back side of the tailgate, remove the two bolts holding your factory camera to the bezel, unplug the factory camera from the harness. To replace simply reverse the order - 15 minutes to install!