Chrysler/Dodge/Jeep Universal backup camera with OBD Programmer for Factory Display

No dealer programming required!



* Required Fields


Email to a Friend



This is a high quality OEM integrated backup camera solution for several Chrysler/Dodge vehicles that integrates right into your 8" factory display screen! No dealer programming is required making this a simple OEM integrated solution for your vehicle  The camera can be mounted on the license plate or it also comes with a mini mount that will allow you to mount the camera to the ledge above the license plate if you choose.


The kit comes with the following:

  • Dual mount camera system with high grade Super CMOS sensor for an ultra clear view, mount on license plate or lip mount as desired
  • Full chassis harness
  • Factory radio integration harness (Monitor not included)
  • OBD programming module
  • Required mounting hardware/connectors

Camera Specifications:

  • Camera Source exclusive Super CMOS high grade sensor with night vision
  • Selectable parking guidelines (can be turned off if desired)  NOTE: Black center line is not present on actual display
  • 600 TV lines of resolution
  • <.2 lux minimum illumination - Outstanding night vision!
  • 170 degree viewing angle

System has a 3 year warranty!

**Monitor not included.**

Additional Information

Additional Information

Video System NTSC
Vehicle Interface Includes Factory Integration Module
Waterproof/Dustproof Level IP 67
Night Vision .3 Lux
Power Supply 12 Volts
Wiring Type Hard Wired Full Harness
System Manufacturer EVI Systems
Camera Resolution 600 TVL
Parking Guidelines Selectable on/off
Camera Orientation Rear Facing
Fit Type Universal fit
Connection Plug and Play to Factory Dash Display
Sensor Type CMOS III
Viewing Angle 170 Degrees
Warranty 3 Year Limited

Compatible with the listed vehicles that have the REC,RER, MyGig, RA3, RA4 8" factory display screen without "hands free" bluetooth system.

Not compatible with 4.3" screen.

Chrysler 200 2011-2014
300 2008-2011
Aspen 2008-2009
Sebring 2007-2010
Town&Country 2008-2016
Dodge Avenger 2007-2014
Caliber 2009-2012
Challenger 2008-2014
Charger 2008-2010
Dakota 2008-2011
Durango 2008-2013
Grand Caravan 2008-2017
Journey 2008-2010
CitiVan 2012-2016
Jeep Commander 2008-2011
Compass 2009-2017
Grand Cherokee 2008-2013
Patriot 2009-2017
Liberty 2008-2012
Wrangler 2007-2017
Installation Information

Install on either your license plate mount or on any flat surface - comes with two brackets. The camera harness will run inside the vehicle to the back of your factory display and you will need to locate a reverse activated 12v power source and ground. 

Make installation even easier with an add on 12 Volt power source to eliminate the need to locate a power source on the vehicle and avoid cutting or splicing into factory wiring!  See related item SKU: CS-RPW-P

You will need to remove your factory radio to install the RCA T-Harness to the back of your factory display. Connect the RCA from the main chassis harness to the T-Harness.

Plug the OBD programmer into the OBD port under the steering wheel and programming is completed in less than a minute!



Q & A

Q:  Where does this camera mount?

A:  Install on either your license plate mount or on any flat surface - comes with two brackets.

Q:  Will this work with my 4.3" factory display?

A:  No, this kit is only compatible with the 8" factory display.