Camera Source is not currently experiencing any shipping delays due to COVID-19.
This harness will allow you to quickly remove a trailer or other removable component with backup camera.
Quickly remove your fifth wheel, trailer, farm machinery, or anything else that requires the camera to be disconnected at the hitch. Heavy duty coil harness locks into matching receptacles on both ends. Screw type locking connectors are a perfect match for all our commercial camera systems. Coil extends to more than 10ft!
NOTE: This kit can handle ONE camera. This harness is designed to run from inside the cab all the way to the rear bumper, then there is a single coil harness that connects to the included trailer pigtail - approximately 30' long. The harness has one connector inside the cab that routes along the chassis to the rear bumper where it goes into the socket with spring loaded lid. The trailer end is a short pigtail that has provisions for 1 camera.
Warranty Information All Camera Source commercial products include a standard 1 year warranty unless otherwise specified in the item description. Simply return the item and it will be repaired or replaced! Note that some issues can be resolved over the phone or email so please contact us first.
|System Manufacturer||EVI Systems|
|Connection||Commercial 4 Pin Coax|
|Warranty||1 Year Limited|
There are three components to this kit; two camera cable connectors and the coiled harness. The camera cable connectors have a locking 4 pin connection on one end that attaches to your camera cable and a female receptacle on the other end where the coiled harness plugs into. This is similar to your trailer harness receptacle in the rear bumper of your truck with a spring loaded lid to protect the connector when not in use. Coiled harness simple pushes into the receptacle and locks into place by a tab on the spring loaded lid - very simple to install!