- Description
-
Details
FMVSS 111 compliant! This is a plug and play camera kit that will allow you to replace your factory tailgate camera with this rear facing flush mount camera!
This universal camera mounts flush with a flat surface. Drill a 22.5mm hole(hole saw included) and run the cable through to your factory backup camera connection.
Kit includes the following:
- Black rear facing surface mount camera with our latest super CMOS camera - the latest camera technology!
- Mounting hardware
- OEM conversion harness
- 5', 10', 25' cable lengths available- select from drop down above
- 22.5 mm hole saw
- Zip ties
- Installation instructions
- 3 year limited camera warranty
Camera Specifications:
-
- Super CMOS chip - outstanding color, contrast, and clarity!
- Removable parking guidelines
- 170 degree view
- 600 TV lines of resolution
- .1 lux minimum illumination - Outstanding night vision!
- Additional Information
-
Additional Information
SKU CS-DTRSK-FM Video System NTSC Waterproof/Dustproof Level IP 67 Night Vision .1 Lux Power Supply 12 Volts Wiring Type Factory Plug&Play System Manufacturer EVI Systems Camera Resolution 600 TVL Parking Guidelines Selectable on/off Camera Orientation Rear Facing Fit Type Universal fit Connection Factory Connector Sensor Type Super CMOS Viewing Angle 170 Degrees Warranty 3 Year Limited - Compatibility
-
RAM: 2013-2018
Any 2013-2018 Ram truck with a factory installed backup camera. This kit relies on the factory camera chassis harness to operate.
**EVI Systems has certified this camera system to comply with FMVSS 111 regulations as set forth by the National Highway Traffic Safety Administration (NHTSA). Testing has been performed jointly in-house and by a certified laboratory to meet or exceed the minimum requirements set forth by TP-111-V-01. FMVSS 111 field of view requirements and any other vehicle related certification is ultimately the responsibility of the vehicle up-fitter to ensure compliance.
- Installation Information
-
Camera requires a 22.5 mm hole on a flat surface for flush mounting. It will require a flat section approximately 1" x 1" for mounting. Drill the hole and connect the camera harness to the OEM conversion harness. Run the cable to your factory backup camera connection under the truck and plug it in.